| Tangit PVC-U is a special and ready for use adhesive for the water resistant gluing of PVC-U (hard). The adhesive fulfills DIN 16970. Clean both surface ends thoroughly with Tangit Cleanser and clean tissue paper. Apply an even layer of adhesive (fitting thin, pipe heavier coated) in an axial direction with a brush. Assemble the parts within 4 minutes (at 20°C) without turning, and hold firmly for a few seconds. Remove excess adhesive The assembled joint should not be disturbed for 5 minutes (below 10°C - 15 min.). For a pressure test wait at least 24 hours, in case of a repair wait 1 hour per bar. |
 |
Tangit PVC-U Adhesive