Tangit PVC-U is a special and ready for use adhesive for the water resistant gluing of PVC-U (hard). The adhesive fulfills DIN 16970. Clean both surface ends thoroughly with Tangit Cleanser and clean tissue paper. Apply an even layer of adhesive (fitting thin, pipe heavier coated) in an axial direction with a brush.
Actual product may vary from the image shown.
Actual product may vary from the image shown.
Overview
Tangit PVC-U is a special and ready for use adhesive for the water resistant gluing of PVC-U (hard). The adhesive fulfills DIN 16970. Clean both surface ends thoroughly with Tangit Cleanser and clean tissue paper. Apply an even layer of adhesive (fitting thin, pipe heavier coated) in an axial direction with a brush. Assemble the parts within 4 minutes (at 20°C) without turning, and hold firmly for a few seconds. Remove excess adhesive The assembled joint should not be disturbed for 5 minutes (below 10°C - 15 min.). For a pressure test wait at least 24 hours, in case of a repair wait 1 hour per bar.
Hazard statements: H225 Highly flammable liquid and vapour.
H315 Causes skin irritation.
H318 Causes serious eye damage.
H335 May cause respiratory irritation.
H336 May cause drowsiness or dizziness.
H351 Suspected of causing cancer .
Precautionary statements: P102 Keep out of reach of children.
P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P260 Do not breathe dust/fume/gas/mist/vapours/ spray.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection/Â…
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P310 Immediately call a POISON CENTER/doctor.
P501 Dispose of contents/container in accordance with national regulations
Manual Tangit PVC-U Adhesive
